Week #5: (2/20-2/23) Progress Reports

This is where you should post your weekly progress reports. Posts should be individual for each member of each group. You should post at least once per week. You may find it convenient to post more than one per week. That is acceptable.
Locked
rjagodowski
Posts: 2370
Joined: Fri Sep 04, 2015 6:59 pm

Week #5: (2/20-2/23) Progress Reports

Post by rjagodowski »

Please post your progress for Week #5 as a Reply to this Topic.
npgrenier0001
Posts: 56
Joined: Thu Sep 21, 2017 11:59 am

Re: Week #5: (2/20-2/23) Progress Reports

Post by npgrenier0001 »

Worked on 3-D printing the parts for the elevators, discussed construction ideas and elevator door operation
mhau
Posts: 42
Joined: Tue Sep 13, 2016 2:39 pm

Re: Week #5: (2/20-2/23) Progress Reports

Post by mhau »

Researched shaft design and elevator car design.
flrosado0001
Posts: 61
Joined: Tue Sep 12, 2017 11:37 am

Re: Week #5: (2/20-2/23) Progress Reports

Post by flrosado0001 »

Worked on wiring the prox sensor, interfacing it with the plc and hmi, and interfacing the IR sensor with the plc.

Fernando Rosado.
asingh0001
Posts: 55
Joined: Wed Oct 05, 2016 10:16 am

Re: Week #5: (2/20-2/23) Progress Reports

Post by asingh0001 »

Tried to build the sauce station using valves and capacitive sensors, which was a FAIL! Brainstorming new ideas and went to home depot with the group for exploring possible parts that could be used for building the sauce station.
Amrit
ajjanczulewicz0001
Posts: 48
Joined: Tue Sep 13, 2016 2:49 pm

Re: Week #5: (2/20-2/23) Progress Reports

Post by ajjanczulewicz0001 »

Researched different door opening mechanisms for the door that we are going to use.
mafitzgerald0001
Posts: 26
Joined: Thu Oct 27, 2016 2:34 pm

Re: Week #5: (2/20-2/23) Progress Reports

Post by mafitzgerald0001 »

worked on door motor as well as looking into door design and placement
Locked

Return to “Weekly Progress Reports - Post Weekly Progress Reports here.”