Page 1 of 1
Week #5: (2/20-2/23) Progress Reports
Posted: Wed Feb 21, 2018 8:17 pm
by rjagodowski
Please post your progress for Week #5 as a Reply to this Topic.
Re: Week #5: (2/20-2/23) Progress Reports
Posted: Tue Feb 27, 2018 10:21 am
by npgrenier0001
Worked on 3-D printing the parts for the elevators, discussed construction ideas and elevator door operation
Re: Week #5: (2/20-2/23) Progress Reports
Posted: Tue Feb 27, 2018 10:22 am
by mhau
Researched shaft design and elevator car design.
Re: Week #5: (2/20-2/23) Progress Reports
Posted: Thu Mar 01, 2018 8:35 am
by flrosado0001
Worked on wiring the prox sensor, interfacing it with the plc and hmi, and interfacing the IR sensor with the plc.
Fernando Rosado.
Re: Week #5: (2/20-2/23) Progress Reports
Posted: Mon Mar 05, 2018 5:26 pm
by asingh0001
Tried to build the sauce station using valves and capacitive sensors, which was a FAIL! Brainstorming new ideas and went to home depot with the group for exploring possible parts that could be used for building the sauce station.
Amrit
Re: Week #5: (2/20-2/23) Progress Reports
Posted: Tue Mar 20, 2018 9:10 am
by ajjanczulewicz0001
Researched different door opening mechanisms for the door that we are going to use.
Re: Week #5: (2/20-2/23) Progress Reports
Posted: Thu Mar 22, 2018 8:34 am
by mafitzgerald0001
worked on door motor as well as looking into door design and placement