Week #7: (3/5-9) Progress Reports

This is where you should post your weekly progress reports. Posts should be individual for each member of each group. You should post at least once per week. You may find it convenient to post more than one per week. That is acceptable.
Locked
rjagodowski
Posts: 2370
Joined: Fri Sep 04, 2015 6:59 pm

Week #7: (3/5-9) Progress Reports

Post by rjagodowski »

Post your progress reports for Week #7 here.

Reminder that next week is Spring Break!
jmllabaly0001
Posts: 45
Joined: Tue Sep 13, 2016 2:41 pm

Re: Week #7: (3/5-9) Progress Reports

Post by jmllabaly0001 »

started cutting up the 10ft unstrut pieces with a handsaw, sawzall preferable.
JoseL.
flrosado0001
Posts: 61
Joined: Tue Sep 12, 2017 11:37 am

Re: Week #7: (3/5-9) Progress Reports

Post by flrosado0001 »

switching over the 820 PLC program into the 830 PLC module. Worked on ladder logic, putting wires in place for I/O.

Fernando R.
ajjanczulewicz0001
Posts: 48
Joined: Tue Sep 13, 2016 2:49 pm

Re: Week #7: (3/5-9) Progress Reports

Post by ajjanczulewicz0001 »

Cutting unistrut pieces with the hacksaw in the backroom. We have all four vertical pieces cut.
mafitzgerald0001
Posts: 26
Joined: Thu Oct 27, 2016 2:34 pm

Re: Week #7: (3/5-9) Progress Reports

Post by mafitzgerald0001 »

Cut unistrut into 4, 4ft poles for outside frame
npgrenier0001
Posts: 56
Joined: Thu Sep 21, 2017 11:59 am

Re: Week #7: (3/5-9) Progress Reports

Post by npgrenier0001 »

Started cutting unistrut pieces with the hacksaw
mhau
Posts: 42
Joined: Tue Sep 13, 2016 2:39 pm

Re: Week #7: (3/5-9) Progress Reports

Post by mhau »

Started on designing motor mount and adapter.
Locked

Return to “Weekly Progress Reports - Post Weekly Progress Reports here.”