Week #11: (4/2-6) Progress Reports.

This is where you should post your weekly progress reports. Posts should be individual for each member of each group. You should post at least once per week. You may find it convenient to post more than one per week. That is acceptable.
Locked
rjagodowski
Posts: 2371
Joined: Fri Sep 04, 2015 6:59 pm

Week #11: (4/2-6) Progress Reports.

Post by rjagodowski »

Post your progress reports for Week #11 here.
flrosado0001
Posts: 61
Joined: Tue Sep 12, 2017 11:37 am

Re: Week #11: (4/2-6) Progress Reports.

Post by flrosado0001 »

Rewired the PLC so it can work properly with the motor that makes the elevator go up and down. Worked on finding different ways on making an door for the elevator car.

Fernando.
jmllabaly0001
Posts: 45
Joined: Tue Sep 13, 2016 2:41 pm

Re: Week #11: (4/2-6) Progress Reports.

Post by jmllabaly0001 »

applied buttons to the plc board and started working on the door function. debating on either adding multiple doors to each floor or just adding 1 door to the elevator cart
JoseL.
mhau
Posts: 42
Joined: Tue Sep 13, 2016 2:39 pm

Re: Week #11: (4/2-6) Progress Reports.

Post by mhau »

Designing roof and floor of elevator car as well as door assembly.
ajjanczulewicz0001
Posts: 48
Joined: Tue Sep 13, 2016 2:49 pm

Re: Week #11: (4/2-6) Progress Reports.

Post by ajjanczulewicz0001 »

Cutting out the holes on the PLC board for the buttons and working on the motor
asingh0001
Posts: 55
Joined: Wed Oct 05, 2016 10:16 am

Re: Week #11: (4/2-6) Progress Reports.

Post by asingh0001 »

Collaborated the sensors with PLC's using relays and made wiring schematics for the system.
sjcastillo
Posts: 29
Joined: Tue Sep 26, 2017 10:20 am

Re: Week #11: (4/2-6) Progress Reports.

Post by sjcastillo »

Reviewing drawing Ideas with the team . Figuring out how to make the augers work . The cheese acted like a break once the cheese fell between the error patch or area that the cheese will accumulated in.
npgrenier0001
Posts: 56
Joined: Thu Sep 21, 2017 11:59 am

Re: Week #11: (4/2-6) Progress Reports.

Post by npgrenier0001 »

Cut out the holes on the board for the buttons and worked on getting the motor to run up and down
Locked

Return to “Weekly Progress Reports - Post Weekly Progress Reports here.”