Week #12: (4/9-13) Progress Reports.
-
- Posts: 2393
- Joined: Fri Sep 04, 2015 6:59 pm
Week #12: (4/9-13) Progress Reports.
Post your progress reports for Week #12 here.
-
- Posts: 48
- Joined: Tue Sep 13, 2016 2:49 pm
Re: Week #12: (4/9-13) Progress Reports.
Cutting the glass for the cart and designing the teeth to catch on the bottom of the elevator door
-
- Posts: 61
- Joined: Tue Sep 12, 2017 11:37 am
Re: Week #12: (4/9-13) Progress Reports.
Wired up the LED Buttons/figuring out the color coding on them.
Labeled the I/O wiring from the PLC's module.
Worked on more ideas for an elevator door.
Interfaced the PLC with a 12VDC motor instead of a 24VDC motor.
Found a better fit of a Prox senor. (Better distance).
Fernando. R.
Labeled the I/O wiring from the PLC's module.
Worked on more ideas for an elevator door.
Interfaced the PLC with a 12VDC motor instead of a 24VDC motor.
Found a better fit of a Prox senor. (Better distance).
Fernando. R.
-
- Posts: 45
- Joined: Tue Sep 13, 2016 2:41 pm
Re: Week #12: (4/9-13) Progress Reports.
Found out the 24volt motor was too powerful for the shaft, it was adding to much force on the up/down functions but we found a 12volt motor that worked perfectly. discussed on either to add a Prox. Sensor to either the bottom of the cart or on the side to read floors when moving up and down. Also added "elevator" music to the voice chip.
JoseL.
-
- Posts: 55
- Joined: Wed Oct 05, 2016 10:16 am
Re: Week #12: (4/9-13) Progress Reports.
Wired all the sensors for stations and did PLC Programming.
Amrit
Amrit
-
- Posts: 29
- Joined: Tue Sep 26, 2017 10:20 am
Re: Week #12: (4/9-13) Progress Reports.
Overall , the concept of demonstrating the all section working with photo eyes seem to work.
-
- Posts: 56
- Joined: Thu Sep 21, 2017 11:59 am
Re: Week #12: (4/9-13) Progress Reports.
Wired up the led buttons, and cut out the plexiglas sheets for the elevator sides
Re: Week #12: (4/9-13) Progress Reports.
Redesgined motor and shaft adapter, assembled elevator car, and designed upper door assembly.