Week #13: (4/16-20) Progress Reports

This is where you should post your weekly progress reports. Posts should be individual for each member of each group. You should post at least once per week. You may find it convenient to post more than one per week. That is acceptable.
Locked
rjagodowski
Posts: 2370
Joined: Fri Sep 04, 2015 6:59 pm

Week #13: (4/16-20) Progress Reports

Post by rjagodowski »

Post your progress reports for Week #13 here.
asingh0001
Posts: 55
Joined: Wed Oct 05, 2016 10:16 am

Re: Week #13: (4/16-20) Progress Reports

Post by asingh0001 »

Built a station for PLC, Panelview, and other electrical connection.
Amrit
flrosado0001
Posts: 61
Joined: Tue Sep 12, 2017 11:37 am

Re: Week #13: (4/16-20) Progress Reports

Post by flrosado0001 »

Finished wiring the LED pushbuttons to the PLC, they're all functioning.
The 12 VDC motor interfaces with the PLC. UP/DOWN.

Fernando R.
sjcastillo
Posts: 29
Joined: Tue Sep 26, 2017 10:20 am

Re: Week #13: (4/16-20) Progress Reports

Post by sjcastillo »

constructed a new method of feeding the cheese. a lot of trials and error was in play. Over the weekend I built an cheese dispenser that works , with a power supply manual with a touch of the on off button. I used a dish dispenser and used 5/8 bolt to mount the rode to make a spinning motion , rearranging the top of the container and cutting out three half inch holes in the button perfected the amount of cheese drop and hold position.
ajjanczulewicz0001
Posts: 48
Joined: Tue Sep 13, 2016 2:49 pm

Re: Week #13: (4/16-20) Progress Reports

Post by ajjanczulewicz0001 »

Sauntering the push buttons for the phones. Attempting to adjust the motor mount. Cutting the plexus glass panels.
jmllabaly0001
Posts: 45
Joined: Tue Sep 13, 2016 2:41 pm

Re: Week #13: (4/16-20) Progress Reports

Post by jmllabaly0001 »

wired pushbuttons to the plc, built a stand up mount to for the buttons and monitor. the buttons are moving the motor UP/DOWN only when holding so we have to re program plc to latch the pushbuttons when they are pushed down
JoseL.
npgrenier0001
Posts: 56
Joined: Thu Sep 21, 2017 11:59 am

Re: Week #13: (4/16-20) Progress Reports

Post by npgrenier0001 »

Wired pushbuttons to the PLC, and started to work out how to incorporate the phone in the program and to attach it to our stand
mhau
Posts: 42
Joined: Tue Sep 13, 2016 2:39 pm

Re: Week #13: (4/16-20) Progress Reports

Post by mhau »

Worked on in-car emergency phone and adjusted motor shaft adapter for 12v motor instead of 24v motor.
Locked

Return to “Weekly Progress Reports - Post Weekly Progress Reports here.”