Week #13: (4/16-20) Progress Reports
-
- Posts: 2383
- Joined: Fri Sep 04, 2015 6:59 pm
Week #13: (4/16-20) Progress Reports
Post your progress reports for Week #13 here.
-
- Posts: 55
- Joined: Wed Oct 05, 2016 10:16 am
Re: Week #13: (4/16-20) Progress Reports
Built a station for PLC, Panelview, and other electrical connection.
Amrit
Amrit
-
- Posts: 61
- Joined: Tue Sep 12, 2017 11:37 am
Re: Week #13: (4/16-20) Progress Reports
Finished wiring the LED pushbuttons to the PLC, they're all functioning.
The 12 VDC motor interfaces with the PLC. UP/DOWN.
Fernando R.
The 12 VDC motor interfaces with the PLC. UP/DOWN.
Fernando R.
-
- Posts: 29
- Joined: Tue Sep 26, 2017 10:20 am
Re: Week #13: (4/16-20) Progress Reports
constructed a new method of feeding the cheese. a lot of trials and error was in play. Over the weekend I built an cheese dispenser that works , with a power supply manual with a touch of the on off button. I used a dish dispenser and used 5/8 bolt to mount the rode to make a spinning motion , rearranging the top of the container and cutting out three half inch holes in the button perfected the amount of cheese drop and hold position.
-
- Posts: 48
- Joined: Tue Sep 13, 2016 2:49 pm
Re: Week #13: (4/16-20) Progress Reports
Sauntering the push buttons for the phones. Attempting to adjust the motor mount. Cutting the plexus glass panels.
-
- Posts: 45
- Joined: Tue Sep 13, 2016 2:41 pm
Re: Week #13: (4/16-20) Progress Reports
wired pushbuttons to the plc, built a stand up mount to for the buttons and monitor. the buttons are moving the motor UP/DOWN only when holding so we have to re program plc to latch the pushbuttons when they are pushed down
JoseL.
-
- Posts: 56
- Joined: Thu Sep 21, 2017 11:59 am
Re: Week #13: (4/16-20) Progress Reports
Wired pushbuttons to the PLC, and started to work out how to incorporate the phone in the program and to attach it to our stand
Re: Week #13: (4/16-20) Progress Reports
Worked on in-car emergency phone and adjusted motor shaft adapter for 12v motor instead of 24v motor.