Week #5: (2/19-22) Eaton Sensor Handouts

[rjagodowski]

Day Class: This week Tuesday followed a Monday schedule due to the President's Day Holiday observance. Continue reading in the Eaton Sensor Handout. You should have completed the section on Photo-Electric devices for last week. This weeks' assignment is to finish reading through the handout. The handout is included at the end of this post for your convenience.

Evening Class: Due to the weather related loss of class last week and the change in schedule this week, we will be holding our class on Tuesday, 2/19. Because of the room scheduling conflict with the Mech-Elect Assembler Training program on our regular Wednesday evening schedule, I will use the 2/19 to cover most of the material in the Eaton Sensors handout, and then we'll discuss the project.

Here is a catalog of Eaton Switches:

EatonSwitches_Vol08_Tab02.pdf

(2.85 MiB) Downloaded 166 times

Note that this is different than the Sensor Learning Course attached below. This document is just to demonstrate the variety of styles available when selecting a limit switch.

This week we will continue working through the Eaton Sensors handout, with our discussion focusing on 2, 3 & 4 wire sensors, sensor timing and time permitting, enclosure ratings.

We'll also spend a bit of time discussing 2-wire, 3-wire and 4-wire sensors. Some supplemental information from Wisc-Online about:

Two Wire Sensors
Three Wire Sensors
Four Wire Sensors

vol08_tab12_Sensor Learning Course.pdf

(1.06 MiB) Downloaded 167 times