Week #13: (4/20-24) IPC Standards, Megger & Hi-Pot Testing

Post Reply
rjagodowski
Posts: 2370
Joined: Fri Sep 04, 2015 6:59 pm

Week #13: (4/20-24) IPC Standards, Megger & Hi-Pot Testing

Post by rjagodowski »

This week we will discuss various IPC standards and what you should be aware of when applying for a company that adheres to specific IPC standards. Here is the link to www.IPC.org.

We'll watch an IPC video on Safety in the ELectronics/Electrical Industry.

Here's an example of what some of the issues IPC standards and certification educate and protect against:
Measles - Delamination - Crazing.pdf
(5.05 MiB) Downloaded 145 times
This document is from EPTAC (Electronic Process Training and Consulting), an internationally recognized solder training and IPC certification corporation.


We will then finish up discussing two pieces of test equipment not used in our curricula, but occasionally seen in use. These are the Mega-Ohmmeter (Megger) and the High Potential (Hi-Pot) tester. They perform related tasks but in different ways. They both test the insulation resistance.

The Mega-Ohmmeter Testing is used to measure the insulation resistance of an electrical system/component/wire.

How to Measure Insulation Resistance with a 1587 Meter.

Hi-Pot Testing is used to stress the insulation and if there is a weakness to induce a failure. That is, the Hi-Pot testing is used to "stress test" for a failure so that it can be repaired before it's put back into service.

Hi-Pot vs. Megger
Post Reply

Return to “EET-255 Advanced Topics in E.E.T./Automation”