Electronic Systems Group

At this point, you should have completed all of the exercises and you are expected to know all of the content presented in the WAM text.

This week you should be performing the experiment to investigate the Input/Output Signals used by the BS2. A printed copy will be available in the lab. The pdf of the lab is attached here: This experiment requires the use of components and equipment here at STCC so this lab must be completed on campus. You will use the Agilent Digital Oscilloscope to take screen shots of the various parts of this lab.

The documents below are provided for support for the lab. They are taken from the Basic Stamp Syntax and Reference Manual. You should READ THEM before performing the experiment.

Cole Lozinski and Korey Houle

Pictures 1 and 2 is High/LOW/Pause

Pictures 3,4, and 5 are Pulsout

Pictures 6 and 7 are Pulsin

Picture 8 is Freqout

Joseph Jagodowski Week #6

1. On time: 25 ms
Off time: 10 ms
2. 40 Hz 25% D.C.
3. Pulsout: 850
Pause: 20
4. Pulsin .47 uF
5. RCTime 40% of potentiometer value
6. Freqout 1 kHz

Jorge Gonzalez

Pic #1 - 40Hz and 25% Duty Cycle

Pic #2 PULSOUT 650 and PAUSE 18

Pic #3 PULSIN Capacitor 0.22 microfarad

Pic #4 RCTIME with 60% of 10k ohm pot

Pic #5 FREQOUT, 10, 5000, 2000

Week 6

1.High low Pause
2.Pulsout
3.pulsin
4.RCruntime
5.frequout

1.High low Pause
2.Pulsout
3.pulsin
4.RCruntime
5.frequout