Week #5 (2/20-2/24) Weekly Progress Report

Locked
rjagodowski
Posts: 2371
Joined: Fri Sep 04, 2015 6:59 pm

Week #5 (2/20-2/24) Weekly Progress Report

Post by rjagodowski »

Post your progress, contributions, work and anything else you did for the Team project here.

There will be a separate Topic for each week during the semester.

These are individual posts, so each member must post their own progress report. If you worked with others, or the entire group, then you can mention that in your post as well. But each member must post to receive credit for this week's post.
rpoznyur2101
Posts: 66
Joined: Thu Sep 08, 2022 10:49 pm

Re: Week #5 (2/20-2/24) Weekly Progress Report

Post by rpoznyur2101 »

This week was really good, I continued with the woodwork for the hopper, cut out 2 2x4 boards and a base for it. Joe and Rigo did programming on the conveyor, while Jake finished up putting the sensors into the hopper. Vlad continued working on the stepper motors.
jhgirouard2101
Posts: 64
Joined: Thu Sep 08, 2022 3:24 pm

Re: Week #5 (2/20-2/24) Weekly Progress Report

Post by jhgirouard2101 »

I soldered the connections of the vibrators for the hopper and tested it to make sure it allowed the golf balls to pass. Rigo and Joe worked on programming, Ruvim did some more woodwork, and Vlad worked with the stepper motors.
reespinoza2101
Posts: 29
Joined: Thu Sep 22, 2022 12:07 am

Re: Week #5 (2/20-2/24) Weekly Progress Report

Post by reespinoza2101 »

Joe and I work on finishing and touching up the programming while Vlad worked with the stepper motors, Jake finished up putting the sensors into the hopper and Ruvim did some more woodwork.
Jbraco0001
Posts: 45
Joined: Fri Sep 06, 2019 9:43 am

Re: Week #5 (2/20-2/24) Weekly Progress Report

Post by Jbraco0001 »

week 5 still continuing the plc with Greyton and Rigo
Locked

Return to “Progress Reports for Golfball Group”