Week #7 (3/6-3/10) Weekly Progress Report

Post Reply
rjagodowski
Posts: 2371
Joined: Fri Sep 04, 2015 6:59 pm

Week #7 (3/6-3/10) Weekly Progress Report

Post by rjagodowski »

Post your progress, contributions, work and anything else you did for the Team project here.

There will be a separate Topic for each week during the semester.

These are individual posts, so each member must post their own progress report. If you worked with others, or the entire group, then you can mention that in your post as well. But each member must post to receive credit for this week's post.
jhgirouard2101
Posts: 64
Joined: Thu Sep 08, 2022 3:24 pm

Re: Week #7 (3/6-3/10) Weekly Progress Report

Post by jhgirouard2101 »

We touched up the PLC program and worked on the new hopper.
Jbraco0001
Posts: 45
Joined: Fri Sep 06, 2019 9:43 am

Re: Week #7 (3/6-3/10) Weekly Progress Report

Post by Jbraco0001 »

week 7 we are still continuing the plc, we switched to a micro 850 instead of the 820. communications is proving to be an issue
rpoznyur2101
Posts: 66
Joined: Thu Sep 08, 2022 10:49 pm

Re: Week #7 (3/6-3/10) Weekly Progress Report

Post by rpoznyur2101 »

This week, Greyyton, Joe and Rigo continued with the PLC. I continued with the wood work, made sure the hopper and ramp were in good condition. Vlad helped out with hopper as well as with the PLC.
vaseleznev2001
Posts: 60
Joined: Tue Nov 09, 2021 9:12 am

Re: Week #7 (3/6-3/10) Weekly Progress Report

Post by vaseleznev2001 »

Finished 3d printing another insert for the golfball packaging box.
Discussed mounting methods for the servo motors on the ramp.
Cut a couple pvc pipes to correct length at home.
Started writing some code for the Fanuc Robot.
reespinoza2101
Posts: 29
Joined: Thu Sep 22, 2022 12:07 am

Re: Week #7 (3/6-3/10) Weekly Progress Report

Post by reespinoza2101 »

This week, Greyyton, Joe and i continued with the PLC. Ask Vlad to make some 3d prints.
Post Reply

Return to “Progress Reports for Golfball Group”