Week #13 (4/17-21) Weekly Progress Report

[rjagodowski]

Post your progress, contributions, work and anything else you did for the Team project here.

There will be a separate Topic for each week during the semester.

These are individual posts, so each member must post their own progress report. If you worked with others, or the entire group, then you can mention that in your post as well. But each member must post to receive credit for this week's post.

[rpoznyur2101]

This week went very well! Greytton and Joe worked on the fanuc and plc, Vlad worked on some 3d printed part. Rigo assembled the ramps together. Jake was able to help out with the pvc section of the project. I cut a hole inside one of the pvc holes, cut a bigger hole in a 3d printed part, and did some more wood cutting.

[jhgirouard2101]

Tested some more final positions for the hopper/ conveyor along with more PLC work. Vlad printed out the EOAT for the Fanuc.

[Jbraco0001]

this week Greyton and I got the HMI working nice.

[reespinoza2101]

I was able to get the ramps togethor and mounting and and placing the stepper motor for the ramp and on the placements for them in the final project as well and mess with some 3D prints with Vlad for the stepper motor and redesigning our boxes as we can to a little issue