Week #12 (4/8-12): StampWorks Experiments - Week #5
Posted: Sun Mar 24, 2019 2:26 pm
This is should be your fifth week working on the StampWorks Experiments. By this time you should have completed all of the regular experiments. If not, continue working. If you have finished them, you can attempt the extra-credit experiments.
After that, there are a couple of other experiments to be done using your regular Board of Education (StampWorks board not required). These experiments will investigating the PING Ultrasonic Sensor for several experiments and a 4x4 keypad interface. They are posted Here, in Week #14 & #15.
You MUST demonstrate at least one of your completed experiments to your instructor each time you are in the lab or you will not receive credit for your posts. I will then verify your post with an edit added to your post with a statement similar to "Verified 3/29/22 by RJ"
Stampworks lab information and assignments were originally posted here in Week #7.
The assignments have been copied again below for your convenience:
The Stampworks Manual can be downloaded here.
The BS2 programs for all of the StampWorks Experiments are contained in this zip file: You will notice that the list below begins with Experiments #26 & #27, then back to Experiment #10. It is advised you perform these Experiments in this order.
The required experiments in the StampWorks Manual are:
Experiment #26: Hobby Servo Motor Control
Experiment #27: Stepper Motor Control
Experiment #10: A Digital Clock
Experiments #11, 12 & 13: Using an LCD Display
Experiment #16: Frequency Measurement
Experiment #17: Advanced Frequency Measurement
Experiment #18: A Light Controlled Theremin
Experiment #21: Analog Input with PULSIN
Experiment #22: Analog Output with PWM
Experiment #28: Voltage Measurement
Additional Experiments (Extra-Credit) are:
Experiment #31: Advanced 7-Segment Multiplexing*
Experiment #32: I2C Communications*
Experiment #33: Using A Real-Time Clock
*These Experiments require external parts not contained within the StampWorks Board Inventory. See your instructor for these components.
After that, there are a couple of other experiments to be done using your regular Board of Education (StampWorks board not required). These experiments will investigating the PING Ultrasonic Sensor for several experiments and a 4x4 keypad interface. They are posted Here, in Week #14 & #15.
You MUST demonstrate at least one of your completed experiments to your instructor each time you are in the lab or you will not receive credit for your posts. I will then verify your post with an edit added to your post with a statement similar to "Verified 3/29/22 by RJ"
Stampworks lab information and assignments were originally posted here in Week #7.
The assignments have been copied again below for your convenience:
The Stampworks Manual can be downloaded here.
The BS2 programs for all of the StampWorks Experiments are contained in this zip file: You will notice that the list below begins with Experiments #26 & #27, then back to Experiment #10. It is advised you perform these Experiments in this order.
The required experiments in the StampWorks Manual are:
Experiment #26: Hobby Servo Motor Control
Experiment #27: Stepper Motor Control
Experiment #10: A Digital Clock
Experiments #11, 12 & 13: Using an LCD Display
Experiment #16: Frequency Measurement
Experiment #17: Advanced Frequency Measurement
Experiment #18: A Light Controlled Theremin
Experiment #21: Analog Input with PULSIN
Experiment #22: Analog Output with PWM
Experiment #28: Voltage Measurement
Additional Experiments (Extra-Credit) are:
Experiment #31: Advanced 7-Segment Multiplexing*
Experiment #32: I2C Communications*
Experiment #33: Using A Real-Time Clock
*These Experiments require external parts not contained within the StampWorks Board Inventory. See your instructor for these components.