Week #4 (2/12-16): Progress Reports
-
- Posts: 2383
- Joined: Fri Sep 04, 2015 6:59 pm
Week #4 (2/12-16): Progress Reports
Please post your progress for Week #4 as a Reply to this Topic.
-
- Posts: 36
- Joined: Thu Dec 14, 2023 9:58 am
Re: Week #4 (2/12-16): Progress Reports
Identified motor, constructed a contraption with a broken trainer box to power motor. Polarity does not seem to matter. Pumped fluid at a passable speed. Found residual pressure after pumping, may need relief valve of some sort to reduce spillage.
- Attachments
-
- XSPM27-12ADH DC 6V 9V 12V Small Mini Air Pump Micro RF-370CA Motor 4.8mmshatf Oxygen Pump DIY Aquarium Water Fish Tank 70KPa
- 20240215_100548.jpg (1.65 MiB) Viewed 101 times
Last edited by whenry0001 on Sat Feb 17, 2024 9:48 pm, edited 1 time in total.
-
- Posts: 51
- Joined: Sun Nov 26, 2023 2:55 pm
Re: Week #4 (2/12-16): Progress Reports
We changed our plan for the food dispensers and we didn't have the materials yet, so we talked about how we could program it. I was working with Eric and Genesis.
Re: Week #4 (2/12-16): Progress Reports
will constructed the first design for the air-pump/bottle combo and it seems viable.
produce another two bottles in similar fashion and connected and air-pump to another.
decided to store the bottle setup underneath table.
produce another two bottles in similar fashion and connected and air-pump to another.
decided to store the bottle setup underneath table.
-
- Posts: 16
- Joined: Wed Oct 04, 2023 11:47 am
Re: Week #4 (2/12-16): Progress Reports
I discussed with Eric and Sam, and we all agreed that the gumball machine was complicated, and Erick came up with the idea to use a pringles and soup can.
-
- Posts: 23
- Joined: Fri Sep 06, 2019 9:45 am
Re: Week #4 (2/12-16): Progress Reports
we started with the programming of the drink portion and discussed how to go about it with chuck