Week #7 (3/4-3/8): Progress Reports
-
- Posts: 2383
- Joined: Fri Sep 04, 2015 6:59 pm
Week #7 (3/4-3/8): Progress Reports
Please post your progress for Week #7 as a Reply to this Topic.
-
- Posts: 51
- Joined: Sun Nov 26, 2023 2:55 pm
Re: Week #7 (3/4-3/8): Progress Reports
Jacob, Genesis, and I had help with SolidWorks from Samuel and tested our 3D printed Dobot cup holder attachment. We have to make a couple changes to it. I also played with the Fanuc a little more but there's not much I can do with it until we get a cup dispenser and the cup holder done.
Re: Week #7 (3/4-3/8): Progress Reports
decided on 3d printing another cup holder for the do-bot as well as clamps for the fanuc
made slight progress with the do-bot programming (need to discuss further with chuck)
spoke to rick about the programming for the drink dispenser. recommended i use a different servo and to make a flow chart to better understand the desired function of my program.
talked to chuck about the program and he helped us figure out how to better implement our idea.
made slight progress with the do-bot programming (need to discuss further with chuck)
spoke to rick about the programming for the drink dispenser. recommended i use a different servo and to make a flow chart to better understand the desired function of my program.
talked to chuck about the program and he helped us figure out how to better implement our idea.
-
- Posts: 16
- Joined: Wed Oct 04, 2023 11:47 am
Re: Week #7 (3/4-3/8): Progress Reports
Sam, Jacob and I went to the 6th floor to talk to Samuel to 3D print a cupholder using solid works.
-
- Posts: 23
- Joined: Fri Sep 06, 2019 9:45 am
Re: Week #7 (3/4-3/8): Progress Reports
talked to sam about using solidworks and got a prototype for the dobot claw printed and also smoothed out the fanuc programming
-
- Posts: 36
- Joined: Thu Dec 14, 2023 9:58 am
Re: Week #7 (3/4-3/8): Progress Reports
Outlined outputs from PLC to Dobot/Fanuc. Established which PLC modules I'd use to have more outputs available.