Week #11 (4/1-5): Progress Reports

[rjagodowski]

Please post your progress for Week #11 as a Reply to this Topic.

[smfrechette2201]

I measured and cut wood for the frame. I tried to get our 3D printed claw onto the Fanuc. I also read a little about the Fanuc I/O but didn't get anywhere other than identifying a couple wires.

[a_cotto]

claw for the fanuc was finished.
fine tuning on claw placement and function.
wood frame was completed
cup dispenser was ordered but it was too small waiting for a new one in the mail.
fine tuning the do bot program

[whenry0001]

Cut wood for housing
Assembled plug with JST connectors and CAT-6

[ggcabassacabrera2201]

Sam, Adrien and I measured and cut wood.